CarPro Cquartz Gliss 2.0 | Hyper-Slick Top Ceramic Coating

Description

CarPro Gliss 2.0 is all about slickness – whether youre topping a base coat or going solo, it adds serious glide, gloss, and protection to your paint.

CARPRO CQUARTZ Gliss 2.0 isnt just a top coat its a refinement layer. Whether youre finishing off a base of CQUARTZ or running it solo, Gliss gives your paintwork that next-level slickness and clarity thats instantly felt and seen. Its engineered with enhanced oleophobic properties, meaning it actively resists oils, fingerprints, grime and water spotting keeping your finish looking fresh for longer.

But the real standout is the touch. Its one of the slickest ceramic coatings weve ever used making maintenance effortless and contact washing safer. Water sheets right off. Dirt struggles to stick. Your drying towel will glide across panels. And with a water contact angle of over 110, youre looking at serious hydrophobic behaviour backed by 12+ months of durability.

Gliss 2.0 works on gloss, matte, or satin finishes with zero compromise. And if youre already coated in DQUARTZ or CQUARTZ, Gliss steps in as the perfect top layer adding visual pop, protection, and real-world ease without altering the underlying finish.

Features & Specifications:

• Extreme Slickness: Creates an ultra-smooth, low friction finish
• Hydrophobic & Oleophobic:Repels water, oil, and light contamination with ease
• Versatile Use:Works as a top coat or a standalone coating
• Finish Safe:Compatible with matte, satin and gloss finishes
• Durability:Lasts 12+ months with proper care
• Water Contact Angle: >110 for high beading and sheeting
• Working Temps: 10C to 32C

Contents:

• 1x CQUARTZ Gliss 2.0 (30mL, 50mL or 100mL options)
• 1x Foam Applicator
• 4x 10cm x 10cm Suede Microfibers (5x for 100ml)
• CQUARTZ Car Stickers
• 1x User Manual

Application:

Directions: (For use as a primary coat)

1. Wash withCARPRO Reset, decontaminate, and polish withCARPRO Reflect. If heavier cut is needed, may start with CARPRO Ultracut.
   
2. Wipe down withCARPRO Eraser(vehicle must be 100% dry and free of moisture).
3. Drag two lines of product across length of suede wrapped applicator.
4. Apply evenly across surface,approximately 2 ft x 2 ft section at a time. Any overlap from one section to the next must be within a couple minutes for even application.
5. Add more product to applicator as needed to keep a wet, evenapplication.
6. Allow to flash for 2 – 15 minutes depending on climate. 5 – 10 minutes is most typical.
7. Look for it to dry to haze and then wipe off with CARPRO 2-Face towel before it becomes difficult. Wipe off all haze and residue to avoid any high spots.
8. If haze is left on too long then reapply and immediately wipe off.
9. If layering on top of itself, wait 1 hour between coats. If IR cured, you may repeat immediately.

Directions: (For use as a top coat)

1. May be applied 4 hours or longer after applying CQUARTZ.
2. If the base coating is IR cured then Gliss 2.0 may be applied after it cools.